PCB Separate Machine Walking Knife Type Machine Model: R-805A

描述

Equipment parameters:

1 Power supply: single-phase AC110-220V 50-60HZ, 250W.

2 knife material: imported SKD-11 material.

3 Cutting speed can be set to high and low: 300/S-500/S can be switched freely.

4 The quasi-segmentation length is up to 400mm, and there are three other maximum strokes: 600mm, 900mm, and 1200mm. It can also be customized beyond these ranges.

5 The gap between the upper and lower knives can be easily adjusted by turning the hand.

6. PCB maximum cutting length: 400mm.

7 PCB maximum thickness: 0.5-3.2mm.

8 Maximum thickness between V-CUT slots: 0.25-1.0mm.

Features:

1. After connecting multiple PCB boards with solder, the breakage will often damage the circuit or damage the electronic parts. Using this machine can avoid damage and improve work efficiency and quality.

2 With this knife-feed separation, the stress can be completely reduced to prevent solder cracking and part breakage.

3. The knife-type splitting machine is an electric PCB board and aluminum substrate splitting machine that uses an upper circular knife and a lower straight blade. When splitting, the PCB is fixed to the lower knife through the V-groove, and the upper knife is controlled by the foot switch to realize the splitting.

4. The moving stroke of the round knife (that is, the length of the split plate) can be preset, and the setting range is any two groups between 0, 100, 200, 300, and 400mm.

5. The operation is safe. There is a protective blade on the round knife, which will not hurt your hands. It can also be equipped with a safety protection sensor device. When human hands or foreign objects enter the working area, the knife will stop

6. Various PCB thicknesses can be fine-tuned to solve the problem of the depth of the V-CUT groove on the PCB.

7 .The circular knife and the lower straight knife are made of imported SKD-11 material, which is hard and wear-resistant, has a long service life, and the stress of the split plate is small to prevent cracking of solder joints. The blade can also be treated with titanium plating, which is more durable.